05_26767_0F
Page 4
2. lAY OUT ROOF FRAME
• Assembly is easiest if you lay out the roof parts as shown in the location you intend to erect the shelter.
• Start by assembling the center peak then assemble each side.
• All connections will use 2
1
/
2
inch (# 10017) bolts,
EXCEPT
where noted ( ) use 2
inch (# 10114) bolts.
10045
10045
10047
10047
10047
10047
10047
10047
10047
10047
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10244
10045
10045
802105
802105
802105
802105
802105
802105
802105
802105
802105
802105
802105
802105
802104
802104
802104
802104
802104
802104
802104
802104
802104
802104
802104
802104
10046
10046
10048
10048
10048
10048
NOTE:
Install all
carriage bolts with the
nut toward the center
of the frame.
1. PlOT THE lOCATION
Before building your canopy, choose a flat area and plot your location.
A.
With enclosed Spikes (10431), stake out the area for the canopy in the desired spot.
The width (W) of the area should be at least equal to the width of the canopy (18 FT.)
and the length should be at least equal to the length (L) - 30 FT.
B.
To be sure the staked area is square, tie a rope diagonally from corner to corner.
C.
Measure from where the two ropes intersect each other to all 4 corners. These
measurements (A and B) should be the same. If they are not equal the spikes need to
be adjusted until the width, length and inside measurements are correct.
18 ft. W
30 ft. L
B
A
Toll-Free
1-866-667-8454
NorthlineExpress.com
www.NorthlineExpress.com
