ShelterLogic Shed-In-a-Box E Series, Assembly Instructions Manual

Page: 8 / 24

Detail g
Detail H
Detail I
CROSS POLE
3-WAY SIDE
CONNECTOR
WEBBINg
POCKET
WEBBINg
AND RATCHET
zIPPER
COVER
FRAME
POLES
SIDE VIEW
WEBBINg
WEBBINg
WEBBINg
FRAME
POLES
POCKET
INSIDE VIEW
WEBBINg, RATCHET AND
“S” HOOK CONNECTOR TO FRAME
FRAME FOOT
Detail J
Page 7
WEBBINg
05-70401-5-OD
c. When properly installed, the doors will wrap around the frame and the web-
bing will be exposed to the inside of the building as shown in Detail H and i.
D. tighten the panel by inserting the “S” Hooks into the holes in the corner
legs, pulling tightly and tying off as shown. See Detail j. Repeat this step for
the other panel door.
5. SECURE COVER AND BOTTOM CROSS RAILS:
A. After pulling the cover over frame, the welded-in straps (webbing)
should be at the front and back corners of the shelter. Adjust the cover
so it sits evenly on the frame.
NOTE: The pocket at the bottom, along the sides of the cover, should
be on the inside as shown in Detail K.
B. Insert the (4) “S” Hooks with ratchet clamps into outside frame foot
holes as shown in Detail L. Tighten and adjust as necessary. The fit
should be snug.
c. inside, assemble the cross-rail poles at one side, loosely attach the
corner brackets, then slide the poles through the fabric pockets at each
leg. Repeat this on the other side. See Detail M.
CROSS RAILS
AND POCKETS
WEBBINg-OUTSIDE VIEW
The ratchet should be checked monthly to make sure the
cover is secure.
“S” HOOK HOLE
Detail K Detail L
800178
800179
and
INTERIOR
WEBBINg