background image

STEP 7

STEP 6

Depending on the model you have purchased, your 

base feet will either fit onto the outside of the leg poles,

or slide inside the leg poles. After installing Base Feet

Plates onto bottom of Support leg Poles, be sure to 

line up the predrilled hole in the leg with the predrilled

hole in the base foot. Insert 5/16" x 3" bolts all the way

through leg and foot to other side, secure with nuts.

Note: Don't insert the bolt to the corner legs at this step.

Fig. 5A

Fig. 5B

Locate a suitable location to place 4 anchors as shown

in the illustration into each of the base feet until

the round end of the anchor touches the base feet. 

STEP 5

Position the cover on the side of the frame with the side with the grommets parallel to the frame and facing down.

Go to the opposite side of the frame and throw at least three ropes over the frame (evenly spaced along the length

of the frame). Tie the ropes to the grommets on the cover and use the rope to pull the cover over the frame (the 

more people and ropes you have to pull the cover over the easier it is to do). Position the cover so that the valance

is even front to back and side to side.

corner

 

clamps

11130

690

800220

Fig.7B

middle

clamps

11130

800221

690

Fig.7A

Fig.7

Pocket Pipe

Fig.6

Fig.6A

Fig.6B

Rope

PAGE  4

Slide the pocket pipes into the cover pockets between the cutouts. Attach the pocket pipes to the frame using the 

3 & 4 way clamps (800220 & 800221) and the 5/16 X 2 #11130 bolts and nuts. Check that the pocket pipes are

evenly spaced on both sides of the top pipe. Slide the pocket pipe down the length of the rafters to tighten the top 

section of the cover. When the cover is pulled tight secure the bolts and nuts in the sliding clamps to hold them in 

place. 

 

Tie a loop into the end of the 

rope. Feed the loop over the 

top of the rafter pole and feed

the other end of the rope through

the loop and run the rope down

the leg at least 12" and wrap

the rope  around  the leg and 

feed  the loose  end over the 

rope (Fig.6A).

Take the loose end of the robe

and secure it to the auger an-

chor already secured in the ground

(Fig.6B).Repeat these steps for the

 remaining legs on the canopy.

Reviews: