15
|
P a g e
INSTALLATION
P
OWER
S
OURCE
R
EQUIREMENTS
When selecting a location for the oven, check that
each
of the following requirements is satisfied:
Power Source
: The power source must match the voltage and ampere requirements listed on the
oven data plate. This oven is intended for
220 - 240 volt
,
50/60 Hz
applications at
12 Amps
.
•
The power source must be
single (1) phase
and
protective earth grounded
.
•
The power source for the oven must conform to all national and local electrical codes.
•
Supplied voltage must not vary more than 10% from the data plate rating
. Damage to the
oven may result if supplied voltage varies more than 10%. A separate circuit is recommended
to prevent possible loss of product due to overloading or failure of other equipment on the
same circuit.
Switch or Circuit-Breaker
: A switch or circuit-breaker must be used in the building installation.
•
The required circuit-breaker is 20 Amps
Oven Fuses:
The oven is provided with
two 20 amp fuses
. These are located in holders adjacent to
the power feed braid on the back power panel of the unit.
•
The fuses protect against overcurrent conditions related to the operation of the oven.
•
If one fuse blows, the oven will shut down. For safe operation, the cause of a blown fuse
should be determined prior to replacing it.
Accessory Outlet Fuse:
The oven is also provided with a pair (2) of
2 amp fuses
installed adjacent to
the external power outlet.
•
The fuses protect against overcurrent conditions related to the operation of the outlet and
an attached power exhaust blower.
•
If one fuse blows, the outlet will depower. The cause of a blown fuse should be determined
prior to replacing it.
Power Feed:
The oven must be positioned so that all operators have access to the power feed
disconnect in case of emergencies.
•
The Disconnect must be in close proximity to the equipment and within easy reach of the
operator.
•
The Disconnect must be marked as the disconnecting device for the equipment.
Summary of Contents for SMO5HP-2
