20 |
P a g e
INSTALLATION
I
NSTALL
C
HAMBER
HEPA
F
ILTER AND
D
UCT
Note:
Exercise caution to avoid striking the sensors and blower fan
wheel on the chamber ceiling when installing the duct.
Note:
The incubator must be turned off and unplugged when carrying
out this procedure.
The ring-style chamber HEPA filter traps particulates, as well as
isolating and killing airborne microbes in the incubation chamber.
Perform the following steps to install the filter and ceiling air duct.
Snap the chamber HEPA filter to the mounting collar on the
chamber ceiling air duct.
•
It may be necessary to tilt the filter to one side or the
other.
Snap the filter cap to the HEPA filter.
Move the air duct into the incubation chamber with the
attached HEPA filter facing down.
Mount the back of the air duct on the rear chamber mounting
pins, one pin at a time.
Mount the front of the duct on the front chamber mountings,
one at a time.
Back
Step 1
Filter Cap
Back
Step 2
Step 3
Step 5
Front
Step 4
Rear
Mounting Pin
Chamber
Ceiling Air
Duct
Chamber
HEPA Filter
Front
Mounting Pin