Appendix
-63
Check
• Projector power cord is not plugged into the wall outlet.
• Selected input is wrong. (See page
31
.)
• Cables incorrectly connected to back panel of the projector. (See pages
14
–
23
.)
• “Contrast” and “Bright” adjustments are set to minimum position. (See
page
44
.)
• Picture adjustments are not correct. (See page
44
.)
• Adjust the focus. (See page
25
.)
• Projection distance is too long or too short to allow for proper focus. (See
pages
26
and
27
.)
• OSD Display is set to “OFF”, preventing to display some or all On-screen
Displays. (See page
51
.)
• If the picture is normal, the sound is due to cabinet shrinkage caused by
temperature changes. This will not affect operation or performance of the
projector.
• Refer to “Maintenance Indicators” on page
58
.
• Adjust the “Phase” setting. (See page
48
.)
• Change the input signal type. (See page
52
.)
Problem
No picture appears.
Colour is faded or poor.
Picture is blurred.
No OSD appears.
An unusual sound is
occasionally heard from the
cabinet.
Maintenance indicator
illuminates.
Picture noise appears.
Image is green on INPUT 2
Component.
Image is pink (no green) on
INPUT 2 RGB.
Kensington Security
Standard connector
This projector has a Kensington Secu-
rity Standard connector for use with a
Kensington MicroSaver Security Sys-
tem. Refer to the information that came
with the system for instructions on how
to use it to secure the projector.
Rear View
Using the Kensington Lock
Troubleshooting
XV_Z201E_E_p57_66.p65
03.10.30, 12:19AM
63
Summary of Contents for XV-Z201E
