Sharp V-1, General & Electrics Manual

Page: 19 / 145

SHARP
V-1 KNEE MILL GENERAL MANUAL
CH1-8 KRDM24C0 V4.0S
35. Beware of performing another operation while in close proximity to the rotating parts of
the machine.
36. Be sure spindle is not running when using gauges on the machine.
37. Always wear protection before operating the machine.
(a) Never remove protection for even a short time when operating the machinee.
(b) Wear protective devices correctly.
(c) Know the correct way to wear protective devices.
38. Beware of material and tool flying from the machine.
39. Beware of where you leave tools during set up.
40. Keep protective guards at the point of operation.
(a) Know how to set or attach protective guards properly.
(b) Never use the wrong protective guard.
(c) Know how to select the proper guards.
41. When the spindle and workpiece are in motion, never reach over under or around a
workpiece to make an adjustment.
42. Never reach over, under or around a workpiece to retrieve anything.
43. Never reach over, under or around the workpiece to tighten a machine part.
44. Never reach over, under or around a workpiece to move hand tool to another position.
45. Never reach over, under or around a workpiece to remove swarf.
46. Know the proper procedure for applying loads. Never apply force from an awkward
position.
47. Never mount a workpiece too large for the machine.
48. Never mount a workpiece too large for the operator to handle.
49. Use the equipment necessary for handling workpieces.
50. Never apply undue force on the accessory.
51. Secure all workpieces.
52. Secure all jaws, nuts, bolts and blocks.