EN -10-
CHAPTER -6: TROUBLESHOOTING
If humidity builds up inside the fridge;
•
Has the food been properly packaged? Have the containers been well dried before they were put into the
refrigerator?
•
Are the doors of the refrigerator opened very frequently? When the door is opened, the humidity found in the
air in the room enters the refrigerator. Especially if the humidity rate in the room is too high, the more frequently
the door is opened the faster will be the humidification.
• It is normal to have water drops formed on the back wall following the automatic defrosting process. (In Static
Models)
If the doors are not opened and closed properly;
•
Do the food packages prevent closing of the door?
•
Are the door compartments, shelves and drawers placed properly?
•
Are door gaskets broken or torn?
•
Is your fridge on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the operation of the
compressor, this is normal.
IMPORTANT NOTES:
•
The compressor protection thermal fuse will cutout after sudden power breakdowns or after unplugging the
appliance, because the gas in the cooling system is not stabilised. This is quite normal, and the fridge will
restart after 4 or 5 minutes.
•
The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or ice may occur on the
rear surface of your fridge due to the operation of the compressor in specified intervals. This is normal. There
is no need to perform a defrosting operation unless the ice is excessive.
• If you will not use your fridge for a long time (e.g. in summer holidays), put the thermostat to “•” position. After
defrosting, clean your fridge and leave the door open to prevent humidity and odor build up.
•
The appliance you have purchased is designed for home type use and can be used only at home and for
the stated purposes. It is not suitable for commercial or common use. If the consumer use the appliance in
a way that does not comply with these features, we emphasise that the producer and the dealer shall not be
responsible for any repair and failure within the guarantee period.
•
If the problem persists after you have followed all the instructions above, please consult an authorised service
provider.
Conformity Information
•
This appliance is designed for use at an ambient tem-perature within the 16°C - 38°C range.
•
The appliance is designed in compliance with the IEC60335-1 / IEC60335-2-24, 2004/108/EC standards.
CHAPTER -7: TIPS FOR SAVING ENERGY
1. Always allow foodstuffs to cool before storing in the appliance.
2. Thaw food in the fridge compartment, this helps save energy.
