Sharp SF-2530, Operation Manual

Page: 39 / 92

37
GENERAL INFORMATION
Program No. Program name Description
10 Auditing mode Enables or disables the auditing mode, which controls access to
copier. See page 8.
11 Account number Registers accounts for auditing mode.
entry
12 Account number Changes account numbers for auditing mode.
change
13 Account number Deletes accounts for auditing mode.
deletion
14 Number of copies Displays the total number of copies made against account numbers.
per account
15 Resetting account Resets all audit accounts or resets any desired individual accounts.
16 Auditor code change Changes the auditor code number.
AUDITING PROGRAMS
The auditing programs are used to set the internal auditor functions.
Auditor code number
An auditor code number must be registered before an auditing
program can be used. The auditing manager must remember this
number. Only this registered number will allow access to the auditing
programs. This number is registered as below.
NOTE:
If an optional Auditor (SF-EA12) is installed, the internal auditor
cannot be used. In this case, setting for the auditing programs must
be selected by using an optional Counter Commander (SF-EA13).
The operation of the SF-EA12 and SF-EA13 auditing system is
described in a separate manual.
1 Press the clear (
C
) key, the INTERRUPT key, and the
clear key again.
●
“–– ” will appear in the copy quantity display and “ – – ” will
appear in the copy ratio display.
2
Enter the auditor code number using the 10-key pad.
●
When registering the auditor code number for the first time,
enter the number that was set at the factory. (See page 87.)
●
When the entry is complete, “––” will appear in the copy quantity
display again.
Auditing programs
1 2 3
INTERRUPT
CLEAR ALL
C
1 2 3
4 5 6
7
0
C
8 9
LECT