9
INSTALLATION INSTRUCTIONS
STEP 13: CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit
5
/
8
",
3
/
4
" or 1" diameter
connections on the air gap, waste tee or disposer. Cut on the marked
line as required for your installation.
1"
3/4"
5/8"
Cutting Lines
IMPORTANT: Do not cut corrugated portion of hose
• If a longer drain hose is required, add up to 42" of length for a
total of 10 feet to the factory installed hose. Use
5
/
8
" or
7
/
8
" inside
diameter hose and a coupler to connect the two hose ends. Secure
the connection with hose clamps.
Hose Clamp
Hose Clamp
Coupler
• Secure the drain hose to the air gap, waste tee or disposer with
clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using either
previously determined method.
METHOD 1 – Air gap with waste tee or disposer
Waste Tee Installation
Disposer Installation
METHOD 2 – High drain loop with waste tee or disposer
Waste Tee Installation
18"
Min.
18"
Min.
32"
Min.
32"
Min.
Fasten to underside
of countertop
Disposer Installation
Fasten to underside
of countertop
Remove
Hopper
Plug
IMPORTANT
When connecting drain line to
disposer, make sure that the drain plug has been
removed. DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching dishwasher
drain hose to the disposer.
STEP 14: CONNECT POWER SUPPLY
Skip this step if equipped with power cord. Verify that power is
turned off at the source.
• Remove junction box cover “A”.
• Locate the three dishwasher wires (white, black and green) with
stripped ends. Insert dishwasher wires through the small hole in
the junction box “B”.
• Secure house wiring to the bottom of the junction box with a
strain relief “C”.
• Use wire nuts to connect incoming ground to green, white to
white and black to black “D”.
• Replace junction box cover “E”. Be sure that wires are not pinched
under the cover.
A.
Remove
Junction
Box Cover
B.
Check that White, Black
and Green Dishwasher
Wires are threaded through
hole in back
C.
Insert Power Cord Wires through
Strain Relief and tighten
D.
Use UL Listed
Wire Nuts
E.
Replace Junction
Box Cover
Black
White
Ground
WARNING
If house wiring is not 2-wire with ground, a ground
must be provided by the installer. When house
wiring is aluminum, be sure to use cUL/UL Listed
antioxidant compound and aluminum-to-copper
connectors.
