R-64ST - 28
COMPONENT REPLACEMENT AND ADJUSTMENT
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the single (1) screw holding the green/yellow
wire to the cavity top plate.
3. Disconnect the leads of the power supply cord from the
noise filter, referring to the Figure C-3 (a).
4. Release the power supply cord from the rear cabinet.
5. Now, the power supply cord is free.
Re-install
1. Insert the moulding cord stopper of power supply cord
into the square hole of the rear cabinet, referring to the
Figure C-3 (b). Installation of Power supply cord.
2. Install the earth wire lead of power supply cord to the
oven cavity with one (1) screw and tighten the screw.
3. Connect the brown and blue wire leads of power supply
cord to the noise filter correctly, referring to the Pictorial
Diagram.
Figure C-3 (a) Replacement of Power Supply Cord
POWER CORD REMOVAL
Figure C-3 (b) Replacement of Power Supply Cord
CONTROL PANEL ASSEMBLY REMOVAL
1. CARRY OUT 3D CHECKS.
2. Disconnect the all leads and connectors from the control
unit.
3. Remove the one (1) screw holding the control panel to
the oven cavity and remove the control panel.
4. Lift up the control panel assembly and pull it forward.
5. Now the control panel assembly is free.
1. CARRY OUT 3D CHECKS
2. Disconnect the wire leads to the grill heating elements.
3. Remove the one (1) screw holding the exhaust duct to
the oven cavity.
4. Push the two tabs holding the reflector to the oven
cavity.
5. Release the reflector from the oven cavity by sliding it.
6. Now the grill heating element assembly is free.
7. Remove the grill heater angle from the reflector.
8. Remove the two (2) screws holding the short-plate to
the grill heating elements.
9. Now the individual grill heating elements are free.
GRILL HEATING ELEMENT REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the control panel assembly referring to
"CONTROL PANEL REPLACEMENT".
3. Remove the open lever from the oven cavity front plate
by removing the control panel assy.
4. Disconnect the leads from all switches.
5. Remove the one (1) screw holding the latch hook to
the oven cavity.
6. Remove the latch hook.
7. Remove the switch(s) from the latch hook by pushing
the retaining tab backwards slightly and turning the
switch(s) on the post.
8. Now, the switch(s) is free.
LATCH SWITCH, MONITOR SWITCH AND STOP SWITCH REMOVAL
Figure C-5 Switches
OVEN CAVITY
BACK PLATE
SQUARE HOLE
MOULDING
CORD
STOPPER
POWER SUPPLY
CORD
GROMMET
MOULDING
Latch hook
Tab
SW3: Stop switch
SW2: Monitor switch
SW1: Monitored latch switch
Tab
Tab
POWER SUPPLY CORD
POWER ANGLE
GREEN / YELLOW
WIRE
BLUE WIRE
BROWN WIRE
NOISE FILTER
L
TP
F 8 A
TL
RED
20 A
WHT
N
CHASSIS
SUPPORT
R64ST_S.MANUAL
12/8/01, 11:01 am
28
