R-64ST - 27
Removal
1. Disconnect the oven from the power supply.
2. Remove the turntable and roller stay from the oven
cavity.
3. Turn the oven over.
4. Cut the four (4) bridges holding the turntable motor
cover to the base plate with the cutting pliers as
shown in Figure C-4 (a).
CAUTION: DO NOT DROP THE TURNTABLE MO-
TOR COVER INTO THE OVEN AFTER
CUTTING THE BRIDGES. BECAUSE IT
WILL DAMAGE THE WIRE LEADS OF
THE MOTOR AND IT IS DIFFICULT TO
REMOVE IT OUT OF THE OVEN.
5. Remove the turntable motor cover from the base
plate.
6. Disconnect the wire leads from the turntable motor.
7. Remove the one (1) screw holding the turntable
motor to the oven cavity.
8. Remove the turntable motor from the oven cavity.
9. Now, the turntable motor is free.
Re-install
1. Remove the any sharp edges on the turntable motor
cover and the base plate with the cutting pliers.
2. Re-install the turntable motor to the oven cavity with
the one (1) screw.
3. Re-connect the wire leads to the turntable motor.
4. Insert the tab of the turntable motor cover into the hole
of the base plate as shown in Figure C-4(b).
6. Re-install the turntable motor cover to the base plate
with a LX-CZA001URE0 screw.
Screw
Cutting pliers
Bridges
Bridges
Turntable motor cover
Screw
Turntable motor cover
Base plate
Hole
Figure C-4(b). Turntable Motor Cover Re-install
Figure C-4(a). Turntable Motor Cover Removal
1. CARRY OUT 3D CHECKS.
2. Push the lever of positive lock
®
connector.
3. Pull out the positive lock
®
connector.
CAUTION: WHEN YOU (SERVICE ENGINEERS)
CONNECT THE POSITIVE LOCK
®
CON-
NECTORS TO THE TERMINALS, CON-
NECT THE POSITIVE LOCK
®
SO THAT
THE LEVER FACE YOU (SERVICE ENGI-
NEERS).
Figure C-2 Positive lock
®
connector
Terminal
Push
Pull down
1
2
Lever
Positive lock®
connector
POSITIVE LOCK
®
CONNECTOR REMOVAL
COMPONENT REPLACEMENT AND ADJUSTMENT
TURNTABLE MOTOR REPLACEMENT
R64ST_S.MANUAL
12/8/01, 11:01 am
27