Sharp R-60ST, Operation Manual

Page: 9 / 228

GB-7
ENGLISH
INSTALLATION
BEFORE OPERATION
IMPORTANT SAFETY INSTRUCTIONS
20 cm
30 cm
20 cm
0 cm
min
85 cm
5. Securely connect the plug of the oven to a standard
earthed (grounded) household electrical outlet.
WARNING: Do not place the oven where heat,
moisture or high humidity are generated, (for
example, near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.
1. Remove all packing materials from the inside of
the oven cavity and remove any protective film
found on the microwave oven cabinet surface.
2. Check the oven carefully for any signs of damage.
3. Place the oven on a secure, level surface, strong
enough to take the oven weight, plus the heaviest
item likely to be cooked in the oven. Do not place
the oven in a cabinet.
4. Select a level surface that provide enough open
space for the intake and/or outlet vents.
The rear surface of appliance shall be placed
against a wall.
• The minimum installation height is 85 cm.
• A minimum space of 20 cm is required between
the oven and any adjacent walls.
• Leave a minimum space of 30 cm above the oven.
• Do not remove the feet from the bottom of the
oven.
• Blocking the intake and/or outlet openings can
damage the oven.
• Place the oven as far away from radios and TV
as possible. Operation of microwave oven may
cause interference to your radio or TV reception.
NOTE:
Do not use plastic containers for microwaving if the
oven is still hot from using the GRILL and MIX GRILL
operation because they may melt.
Plastic containers must not be used during above
modes unless the container manufacturer says they
are suitable.
If you are unsure how to connect your oven, please
consult an authorised, qualifi ed electrician.
Neither the manufacturer nor the dealer can accept
any liability for damage to the oven or personal injury
resulting from failure to observe the correct electrical
connection procedure.
Water vapour or drops may occasionally form on
the oven walls or around the door seals and sealing
surfaces. This is a normal occurrence and is not an
indication of microwave leakage or a malfunction.
This symbol means that the surfaces are liable
to get hot during use.
Use only the turntable and the turntable support
designed for this oven. Do not operate the oven
without the turntable.
To prevent the turntable from breaking:
(a) Before cleaning the turntable with water, leave
the turntable to cool.
(b) Do not put hot foods or hot utensils on a cold
turntable.
(c) Do not put cold foods or cold utensils on a hot
turntable.
Do not place anything on the outer cabinet during
operation.
Plug in the oven. The oven display will display: “0:00”, an audible signal will sound once.
This model has a clock function and the oven uses less than 1,0 W in stand by mode.
To set the clock, see next page.