22
R-2S56
6. Re-connect the wire leads to the turntable motor.
7. Insert the tab of the turntable motor cover into the hole
of the bottom plate as shown in Figure C-3(b).
8. Re-install the turntable motor cover to the bottom plate
L with the screw which are removed at the above step 2
as shown in Figure C-3(b).
Turntable
motor cover
Bottom plate
Screw: LX-EZA045WRE0
Tab
Hole
Figure C-3(b). Turntable Motor Cover Re-install
Figure C-4. Washer and O-ring Installation and Grease
Applying.
O-ring
Roots of turntable
motor shaft
Turntable motor
O-ring
Apply the grease hear
Washer
Washer
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the single (1) screw holding the green/yellow
wire to the oven cavity.
3. Disconnect the brown wire lead of the power supply cord
from the fuse holder, referring to the Figure C-6.
4. Release the power supply cord from the rear cabinet,
referring to the Figure C-5 (b).
5. Now, the power supply cord is free.
POWER SUPPLY CORD REPLACEMENT (FOR NEW ZEALAND MODEL)
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the single (1) screw holding the green/yellow
wire to the oven cavity.
3. Disconnect the brown wire lead of the power supply cord
from the fuse holder, referring to the Figure C-5 (a).
4. Cut away the connector.
5. Release the power supply cord from the rear cabinet,
referring to the Figure C-5 (b).
6. Now, the power supply cord is free.
POWER SUPPLY
CORD
OVEN CAVITY
BACK PLATE
GREEN/YELLOW WIRE
BROWN WIRE
OVEN CAVITY
BLUE WIRE
SCREW
CONNECTOR
FUSE HOLDER
Figure C-5(a). Power Supply Cord Replacement (for
Australia)
Re-install
1. Insert the moulding cord stopper of power supply cord
into the square hole of the rear cabinet, referring to the
Figure C-5 (b).
2. Install the earth wire lead of power supply cord to the
oven cavity with one (1) screw and tight the screw.
3. Connect the brown wire lead of power supply cord to the
fuse holder correctly, referring to the Pictorial Diagram.
4. Strip the blue wire lead of the power supply cord for
15mm lengh from its end.
5. Wind the conductor of the blue wire lead of the power
supply cord and the conductor of the wire lead of the
main wire harness each other.
6. Insert them into the connector. And clamp it.
7. CARRY OUT 4R CHECKS.
15 mm
Connector
CE-230
Blue wire lead of power supply cord
Wire lead of the
main wire harness
Conductor:
Stripped portion
Connector
CE-230
Figure C-5 (b) Replacement of Power Supply Cord
SQUARE HOLE
MOULDING
CORD
STOPPER
POWER SUPPLY
CORD
OVEN CAVITY
BACK PLATE
POWER SUPPLY CORD REPLACEMENT (FOR AUSTRALIA MODEL)