EN - 11
Do not overfill the detergent compartment.
Otherwise you can see whitish streaks or
bluish layers on glass and dishes which
may cause glass corrosion. Continued
over-use of detergent may cause machine
damage.
Using too little detergent can result in poor
cleaning and you may see whitish hard
water.
See the detergent manufacturer’s
instructions for further information.
4.9. Filling with
D
etergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each program. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
DETERGENT
4.10. Using
C
ombined
D
etergents
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short
program
.
Please use powder detergents in such
program
.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.11. Rinse-
A
id
Use
Rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If an in-sufficient
amount of rinse aid is used, whitish stains
may be left on the dishes and drying and
washing performance will be impaired.
If too much rinse aid is used you may see
bluish layers on glass and dishes.
4.12. Filling the
R
inse-aid and
S
etting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX
level and then close the cap. Be careful not
to overfill the rinse aid compartment and
wipe up any spills.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
The factory setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
• Touch the
program
button and hold it
down.
• Turn on the machine.
• Hold down the
program
button until
“rA”
disappears. Rinse aid setting follows
water hardness setting.
• The machine will display the last setting.
• Change the level by touching the
program
button.
• Turn off the machine to save the setting
