Sharp Notevision XG-C58X, Service Manual

Page: 29 / 172

29
XG-C58X
XG-C68X
21 Checking and
readjustment of
white balance 1. The adjusting conditions for each
item are as follows:
For RGB input, see Item 7.
For video input, see Item 14.
For COMPO input, see Item 17.
No. Adjustment Items Adjustment Conditions Adjustment Procedures
1. Make sure the white balance is as
specified on the standard monitor.
For readjustment, proceed in the or-
der of RGB input, video input and
COMPO input.
22 Checking color-
related perfor-
mance 1. Receive the color bar signal. 1. Select L1 in the process mode.
Check the performance of Color and
Tint.
23 Checking of
picture-related
performance 1. Receive the monoscope pattern sig-
nal.
1. Select L2 in the process mode.
Check Picture, Brightness and Sharp-
ness.
24 Checking of RGB
performance 1. Receive the RGB signal. 1. Select L4 on the process mode.
Check Picture, Brightness, Red, Blue,
Clock, Phase, H-POS and V-POS.
25 Checking of off-
timer performance 1. Select OFF in the process mode.
Make sure that the off-timer starts
with 5-minute display, counts down
1 minute for 1 second, and turns off
when 0 minute is displayed.
26 Checking of
thermistor perfor-
mance 1. Heat the thermistor with a hair dryer. 1. Make sure the temperature is dis-
played.
27 Automatic sync
operation 1. Receive the phase checking pattern
signal.
1. Make sure that Clock, Phase, H-POS
and V-POS can be automatically
adjusted in the VGA/S-VGA/XGA
mode.
29 Factory settings 1. Make the following settings.
Process
Remote
Destination
adjustment
controller
settings
North-
S4
Factory
American Setting 4
Other S3
Factory
Setting 3
28 Vertical line level
check 1. Receive the RGB signal. 10-step
gray-scale
1. Compare with the vertical line bound-
ary sample, and it must be at the
boundary sample or less. In case that
it is bad, adjust the PSIG-L of the
item 3.
However, it must be within the range
of 190 - 200.
Gradation 2: 1. Upper-gradation correction value to be used.
Gradation 1: 1. Upper-gradation correction value to be used.
Gradation 0: 1. Upper-gradation correction value to be used.
For the model in question, select the name entered in (2) to start the color irregularity correction. If the
set has its optical characteristics rather different from the standard ones or if the set has some color
irregularity lines missing, do the teaching for that set in particular. Use its specified correction coeffi-
cients in making the adjustment.