-26
Image Projection
Basic Procedure
Connect the required external equipment to the pro-
jector before carrying out the following procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page
28
.
1
Plug the power cord into the wall
outlet.
•
The power indicator illuminates red, and
the projector enters standby mode.
2
Press
on the projector or
on the remote control.
•
The power indicator illuminates green.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
•
The lamp indicator illuminates,
indicating the status of the lamp.
Green:
The lamp is ready.
Blinking in green:
The lamp is warming
up or shutting down.
Red: The lamp should be replaced.
•
If the projector is put into the standby
mode and immediately turned on
again, the lamp indicator may take
some time to illuminate.
•
When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds af-
ter the power has been turned on, and
then transmit the commands.
•
When “Anti-Theft” (see page
48
) is set,
the keycode input box will appear. Enter
the keycode.
Note
•
When entering the keycode, press the
buttons previously set on the projec-
tor or the remote control.
•
For details about the Anti-Theft func-
tion, refer to “Anti-Theft (Setting the
Anti-Theft)” on page
48
.
▼
Keycode input box
Volume
buttons
STANDBY
button
ON button
Power
indicator
Lamp
indicator
INPUT
button
INPUT buttons
Volume
buttons
ON button
AV MUTE button
PG-A20X_E_PDF_P26_31.p65
03.4.23, 9:57 AM
26
