Sharp MX 3070, Troubleshooting Manual

Page: 24 / 56

24
Copying Problems
2-SIDED COPYING DOES NOT TAKE PLACE
Check Solution
Does the paper type setting of the
selected tray specify a type of paper
that cannot be used for 2-sided
copying? ■ Check "Paper Tray Settings" in the setting mode.

"Setting mode" → [System Settings] → [Common Settings] → [Paper Settings]
→ [Tray Settings/ Paper Settings] → [Paper Tray Settings] → [Tray Registration]
→ [Feeding Approved Job]
Check the [Tray Settings] in the home screen.
Tap the selected tray, and in the screen that appears, tap the [Paper Property]
key.
If the [Disable Duplex] checkbox in the paper properties screen is , the tray
cannot be used for duplex printing. Change the paper type to a type that can be
used for duplex printing.
Are you using a special size or type of
paper?
■
For the paper types and sizes that can be used for two-sided copying, see
"SPECIFICATIONS" in Start Guide.
Are you copying using settings that
do not allow 2-sided copying? ■ 2-Sided Copy can generally be combined with other modes as required,
however, some combinations are not possible. If a prohibited combination is
selected, a message will appear in the touch panel.
ROTATE COPY DOES NOT WORK
Check Solution
Did you select the copy ratio
manually?
■
Copy using automatic ratio selection.
Are you copying using settings that
do not allow rotate copying? ■ Rotate copying can generally be combined with other modes as required,
however, some combinations are not possible. If a prohibited combination is
selected, a message will appear in the touch panel.
Is "Rotation Copy Setting" disabled in
the setting mode?
■
Check with your administrator.
If you are the administrator, enable [Rotation Copy Setting].

Select [System Settings] → [Copy Settings] → [Condition Settings] → [Rotation
Copy Setting] → [Rotation Copy] in "Setting mode".
ENLARGE/REDUCE DOES NOT WORK
Check Solution
Are the original, paper, and ratio
settings correct? ■ Check if the original size that appears on the screen is correct. After that, check if
the correct paper is selected. Tap the [Ratio] key and then the [Auto Image] key.
The appropriate ratio for the original and paper will appear.
?
!
?
!
?
!