Image Projection
Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
30
.
1
Plug the power cord into the
wall outlet.
•
The POWER indicator illuminates up
in red, and the projector enters
standby mode.
2
Press
on the projector or
on the remote control.
•
The POWER indicator illuminates in
green. After the LAMP REPLACEMENT
indicator illuminates, the projector is
ready to start operation.
Note
•
The LAMP REPLACEMENT indica-
tor illuminates, indicating the status
of the lamp.
Green:
The lamp is ready.
Green blinking:
The lamp is
warming up.
Red:
The lamp should be replaced.
•
If the power is turned off and on right
after again, the LAMP REPLACEMENT
indicator may take time to illuminate.
When “Anti-Theft” is set, the
keycode input box will appear.
•
Enter the keycode.
Note
•
When entering the keycode, press
the buttons previously set on the
projector or the remote control.
Info
•
When “Anti-Theft” is set, enter the
keycode or the input display will not
appear. Even when the signal is in-
put, the display cannot appear.
▼
Projector indicators
LAMP REPLACEMENT indicator
POWER indicator
POWER button
POWER button
INPUT
button
MENU
button
buttons
ENTER
button
INPUT 1/2/3 buttons
MENU button
buttons
ENTER button
▼
Keycode input box
-28
Summary of Contents for M20X - Notevision Digital Video Projector
