![Sharp LC-19D1E/S-BK/WH Service Manual Download Page 72](http://html.mh-extra.com/html/sharp/lc-19d1e-s-bk-wh/lc-19d1e-s-bk-wh_service-manual_1253486072.webp)
LC-19D1E/S-BK/WH
5 – 2
15
IC302
AUDIO CODEC
VH+-1Y
The WM8983 is a low power, high quality stereo codec designed for
portable multimedia applications.
The device integrates preamps for stereo differential mics, and includes
drivers for speaker, headphone and differential or stereo line output.
Advanced on-chip digital signal processing includes a 5-band
equaliser, a mixed signal Automatic Level Control for the microphone or
line input through the ADC as well as a purely digital limiter function for
record or playback.
M8
16
IC303
STEREO-
POWER-AMP
VHIBD5426MU-1Y
BD5426MUV is a stereo power amplifier for the speaker drive.
BD5426MUV has the following feature. 1) A high-quality audio mute is
achieved by the soft switch technology. 2) Pop sound reduction at the
time of power supply ON/OFF
3) Excessive output power limitation function. 4) Protection circuit built-
in which detects the direct-current voltage impression to SP
M8
17
IC304
2CH-MULTI-
PLEXER
VHI7WH157FK-1Y
TC7WH157 is the ultra high-speed multiplexer which used silicon gate
technology. In this machine, it used to as ON/OFF-SW of the DAC-CLK
signal of the I2S-DATA signal input from HDMI-IC to A-CODEC.
M8
18
IC701
1CH-REG
VHIBD9306AF-1Y
BD9306AF is 1CH Switching-regurator IC.
In this model, it generates VLSB14.6V-regurator
M9
19
IC702
9V-REG
VHIPQ1LAX95
This IC generates B9V-regurator.
M9
20
IC703
STEP-DOWN-
CONV
VHI-1Y
This IC generates B3.3V-regurator.
M9
21
IC704
DC/DC-CONV *2
VHI-1Y
This IC generates VGL(-7V)/VGH(B28V)-regurator.
M9
22
IC705
STEP-DOWN-
CONV
VH+-1Y
This IC generates B1.5V-regurator.
M9
[AV-TERMINAL UNIT]
1
IC501
AV-switch
VHIMM1492BJ-1Y
This IC is a 5-input 2-output AV switch controlled by the I2C BUS devel-
oped for use in television.
Because there are 2 outputs, it supports 2 screens and P-IN-P, and also
supports an external output (monitor) pin.
AV
2
IC502
RS-232C-RECEI/
DRIV
VHIIM3221EIP
The MAX3221E is a single driver, single receiver RS-232 solution oper-
ating from a single Vcc supply. The RS-232 pins provide IEC G1000-4-
2 ESD Protection. The device meets the requirements of TIA/EIA-232-F
and provides the electrical interface between an asynchronous commu-
nication controller and the serial-port connector. The charge pump and
four small external capacitors allow operation from a single 3V to 5.5V
supply.
AV
3
IC504
SERIES-REG
VHIPQ050DNA-1Y
This IC generates B5V-regurator.
AV
4
IC505
STEP-DOWN-
CONV
VHI-1Y
This IC generates B5.6V-regurator.
AV
5
IC506
A-AMP *2
VHINJM4565V-1Y
The NJM4565V integrated circuit is a high-gain, wide-bandwidth, dual
low noise operational amplifier capable of driving 20V peak-to-peak into
400
Ω
load.
In this model, it used to the amplifier of the audio L/R signal outputted
from SCART1.
AV
6
IC507
RGB-SW
VHITL52055D-1Y
This IC is a wide-bandwidth, 2-input, 1-output, 3-circuit video switch.
In this equipment, it is used for switching the red green blue signal at
SCART1 or digital broadcasting.
AV
7
IC508
CVBS-SW
VHIMM1507XN-1Y
This IC is a 2-input 1-output single video switch with 75
Ω
driver and
input clamp.
In this equipment, it is used for switching the CVBS signal at SCART1
or digital broadcasting.
AV
8
IC509
5V-REG
VHIPQ1X501M-1Y
This IC can be used for the power regulator circuit up to 0.15A in cur-
rent capacity with the direct current stabilizing supply element that has
the ON/OFF function, the overcurrent protection function, and the over-
heating protection function of the output voltage. In this model, this IC
generates B5V-regurator.
AV
9
IC510
A-OUT-SW
VHITC4053BT-1Y
This IC is a high-speed triple 2-channel multiplexer. In this equipment,
it is used for select the DTV-AUDIO or MPX-AUDIO at the audio output
signal of SCART1.
AV
10
IC202
DVB-T
RECEIVER
RH-IXB964WJZZQ
This is a COFDM (Coded Orthogonal Frequency Division Multiplex)
Demodulator IC. In this equipment, IF signal from the digital tuner is
decoded to MPEG-2 signal, and it is digitally output. Output signal is fed
to the digital processor to implement video/audio decode processing.
This IC is used for digital signal is fed to the digital processor to imple-
ment video/audio decode processing. this IC is used only at digital
broadcasting.
AV
NO REF NO
Name
Part Code
Description
Drawing NO
Summary of Contents for LC-19D1E/S-BK/WH
