EN - 9
2. INSTALLATION
• Before contacting the local Authorised
Service Provider for the installation
of the dryer, check the information in
the user manual to make sure that the
electrical installation and water outlet is
suitable. If they are not, call a qualified
electrician and a plumber to have the
necessary adjustments made.
• It is the customer’s responsibility to
prepare the dryer’s installation place, as
well as the electricity and waste water
installation. Before installation, check
the dryer for damage. If damaged, do
not have it installed. Damaged products
may endanger your health.
• Install the dryer on a stable and flat
surface.
• Run the dryer in a dust-free
environment where the air ventilation
is good.
• The clearance between the dryer and
the floor
should not be
reduced with
objects such as carpets, wood or tape.
•
Do not block the ventilation grills
found on the plinth of the tumble dryer.
• The appliance must not be installed
behind a lockable door, a sliding door
or a door with a hinge on the opposite
side of the tumble dryer, in such a
way that blocks the full opening of the
tumble dryer door.
• Once the dryer has been installed, the
connections must remain stable. When
installing the dryer, make sure that the
rear surface is not leaning on anything
(e.g. tap, socket).
• The operating temperature of the dryer
is +5°C to +35°C. If operated out of this
temperature range, the performance of
the dryer will be affected negatively and
the product will be damaged.
• Be careful when carrying the product
since it is heavy. Always wear safety
gloves.
• Always install the product should be
placed against a wall.
• The rear surface of the product should
be placed against the wall.
• When the product is placed on a stable
surface, use a water level to check if it
is fully stable. If not, adjust the feet until
it becomes steady. Repeat this process
every time you relocate the product.
• Do not place the dryer onto the power
cable.
2.1. Connection to Water Outlet (with
optional drain hose)
In products with a condenser unit, water
accumulates in the water tank during
the drying process. You must empty the
accumulated water
after each drying
process
. Instead of periodically emptying
the water tank, you can also use the water
drain hose provided with the product to
directly drain the water outside.
2.1.1. Connecting the Water Discharge
Hose
1.
Pull and take out the end of the hose at the
back of the dryer. Do not use any tools to
take out the hose.
2.
Fit one end of the water discharge hose,
which is provided with the product, to the slot
from which you have removed the hose.
3.
Fix the other end of the water discharge hose
directly to the water outlet or sink.
ATTENTION:
The hose must be
connected in a manner that it cannot be
displaced. If the hose comes out during
water discharge, there might be flooding in
your house.
IMPORTANT:
The water discharge
house must be installed at a height of 80
cm maximum.
IMPORTANT:
The water discharge
hose must not be bent between the outlet
and the product, folded or stepped over.
2
1
3
Summary of Contents for KD-GCB8S7PW9-DE
Page 1: ...DE KD GCB8S7PW9 DE Trockner Home Appliances Bedienungsanleitung ...
Page 33: ...29 Visit Our Website sharphomeappliances com Service Support 52257381 ...
Page 34: ...User Manual EN KD GCB8S7PW9 DE Home Appliances Tumble Dryer ...
Page 66: ...29 Visit Our Website sharphomeappliances com Service Support 52257382 ...
