Sharp IG-GC2EU, Operation Manual

Page: 111 / 115

E-11
SPECIFICATIONS
Remove the claw.
Insert to the claw.
Take the unit holder. (see E-9)
Remove the claw of unit holder and remove
the Plasmacluster Ion Generating Unit.
Please do not dispose of the unit holder.
1. Attach a new Plasmacluster Ion
Generating Unit to the unit holder.
2. Reattach the unit holder to the main unit.
3. Reattach the main unit cover and filter
cover.
Insert the car adapter in the accessory socket and check the unit
replacement light is turned OFF.
• After replacement, you may hear the sound “Zi, Zi ...” (sound
generated by Plasmacluster Ion) become louder, however, it is
simply because the Plasmacluster Ion Generating Unit has been
replaced with a new one. It is not a failure.
Note
Model IG-GC2EU
Power Car Adapter
Rated input DC 12 V
Rated output DC 5 V (Max. 2 A for 2 ports)
Operation mode LOW MED TURBO
Power consumption 0.5 W 0.7 W 1.8 W
Ion density
Approx. 7,000
ions/cm
3
Approx. 25,000
ions/cm
3
Approx. 75,000
ions/cm
3
Operating noise level 19 dB 23 dB 36 dB
Outer dimensions
Upper dimension: 74 mm / Lower dimension 65 mm /
Height: 162 mm
(Excluding accessories)
Weight Approx. 265 g (Excluding accessories)
Capacity applicable for high-density
Plasmacluster 25000
*
1
Approx. 3.6 m
3
*
2
* 1 It is the index of capacity that approximately 25,000 ions blown out to the air can be
measured at the point near the centre of the space (0.5 m height from floor) when
the air volume is “MED” by placing the unit at the place supposing a cup holder
beside the driver's seat.
* 2 Space corresponding to a cabin measuring 1.5 (width) x 2.4 (depth) x 1.0 (height)
metres.
* Some specifications may be changed for improvement purposes.
How to replace the Plasmacluster Ion Generating Unit
1
2
3