<P=005>
Setting 21: JUNK FAX NUMBER CHECK
Press
1
to prevent reception from fax numbers entered in the Anti Junk Fax List. Press
2
to
allow reception from all numbers.
•
Initial setting:
2
Setting 22: ALARM VOLUME
This sets the volume of the beep sound which alerts you to error conditions and informs you
that operations have been completed. Press "
1
" for high, "
2
" for middle, "
3
" for low, or "
4
" to turn
the alarm off.
•
Initial setting:
3
Setting 23: DIAL MODE
This sets the mode of dialling. Press
1
if you are on a tone dial line, or
2
if you are on a pulse
dial line.
•
Initial setting:
1
Setting 24: QUICK ON LINE
When you transmit a multi-page document, this setting determines whether your fax will dial the
receiving party and begin transmitting while scanning is still in progress, or wait until all pages
have been scanned before dialling. Press "
1
" to have the fax dial and begin transmission while
scanning is still in progress, or "
2
" to have it wait until all pages have been scanned.
•
Initial setting:
1
Setting 25: MULTI TTI
If you are using Department Control, you can press "
1
" to have the department name (the name
associated with the department code entered by the operator to access the fax) appear at the
top of each transmitted document. This will appear in place of the name entered in "Entering
Your Name and Fax Number" in Chapter 2. Press "
2
" to turn Multi TTI off (the sender’s name
entered in Chapter 2 will appear).
•
Initial setting:
2
Setting 26: BEEP LENGTH
This sets the duration of the beep which signals the end of transmission, reception, or copying.
Press "
1
" for 3 seconds, "
2
" for 1 second, or "
3
" for no beep.
•
Initial setting:
1
Setting 27: DEPARTMENT CODE DIGITS
This setting allows you to change the number of digits used for Department Codes. Enter any
number from "
3
" to "
9
".
•
Initial setting:
4
Setting 28
: PBX RECALL
This sets the recall mode used for transferring calls on a PBX or utilising BT Network services.
Refer to your PBX manual or consult your supplier for the correct setting if the factory setting is
inappropriate. Enter "
1
" for earth recall, "
2
" for time break recall, or "
3
" for no operation.
•
Initial setting:
2
OPTIONAL SETTINGS
OPTION SETTINGS
5-5
