Sharp Elite PRO-60X5FD, Service Manual

Page: 41 / 88

PRO-60/70X5FD
5 – 15
11. Factory setting
After completing the factory setting, pull out the AC cord to complete the setting.
CAUTION: Do not turn on the power after completing the factory setting. If the power is turned on, configure the factory setting again.
12. Software version
1. Main microcomputer
BSMK_X5FD_xxx.USB
BSMK_X5FD_xxx.DAT
BSMK_X5FD_xxxxxxx.PCC
2. Monitor microcomputer
BMELMxxx.SMB
13. An anti-crosstalk measure at the time of the low temperature
• It is a function to control a picture gain depending on the value of the thermistor on the board to reduce crosstalk at the time of the low tempera-
ture.
• The value of the thermistor is confirmed in “TEMPERATURE” of 1/29 pages menus in a process.
• When change the parameter of this function, turn on “CROSSTALK ADJ MODE” of 25/29 pages menus in a process.
• The other parameters of 25/29 pages menus support the following graph in a process.
• For a function to control a picture gain, a screen darkens depending on setting.
• Because the most suitable value is set by default, please do not usually change it.
Adjustment point Adjustment conditions Adjustment procedure
1 Factory setting Complete the setting by
pulling out the AC cord. • Point the cursor to [INDUSTRY INIT (+Cause)], set to “ON” using [+]/[-] of the [VOL]
key, and press the [ENT] key.
The version confirmation screen appears on the green screen. It is completed when
[SUCCESS] is displayed at the top.
(If error occurs, [ERROR] is displayed on the red screen.)
• Turn off the AC power.
The following items are initialized when configuring the factory setting.
1) User set value
2) Channel data (broadcasting frequency, etc.)
3) Password setting value
4) Operating time
5) Standby Cause
6) Auto installation flag
7) V-CHIP block setting value
CROSSTALK GAIN1
CROSSTALK GAIN2
CROSSTALK GAIN3
CROSSTALK TH4
Panel surface temperature
(A thermistor value)
Picture gain
CROSSTALK TH3
CROSSTALK TH2
CROSSTALK TH1