Sharp DM-1500, Service Manual

Page: 39 / 188

(2) Set the charger cleaner to the transfer unit, and move it reciprocal-
ly a few times in the arrow direction shown in the figure below.
E. Charger wire replacement
(1) Remove the TC cover and remove the screw.
(2) Remove the spring and remove the charger wire.
(3) Install a new charger wire by reversing the procedures (1) and (2).
At that time, be careful of the following items.
●
The rest of the charger wire must be within 1.5mm.
●
The spring hook section (charger wire winding section) must be
in the range of the projection section.
●
Be careful not to twist the charger wire.
2. Operation panel section
A. List
No. Part name Ref.
1 Operation panel unit
2 Operation PWB
B. Disassembly procedure
(1) Remove the screws (4 pcs.), the harness, and the operation panel
unit.
(2) Remove the screws (3 pcs.) and the PWB holder.
(3) Remove the screws (3 pcs.) and the operation PWB.
1)
2)
3)
4)
1mm
1.5mm
1)
1)
2)
3)
Charger wire
Protrusion
1)
2)
3)
1)
1)
4)
3)
1)
2)
3)
3)
Note that there are 13 pawls
DM-1505
7 – 2