Sharp DK-UH2, Operation Manual

Page: 20 / 33

E-9
ENGLISH
DK-UH2
DK-UH2(BK)
Basic Operation
Setting the clock
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
[When the unit is in the power stand-by mode]
Press the CLOCK button. The time display will appear for about 10
seconds.
[When the power is on]
Press DISPLAY button on the remote control to toggle between the
function information and clock display.
Press the CLOCK button. The time display will appear for about 10
seconds.
Notes:
The clock will continue counting for 8 hours should there be a
power failure or the AC power lead becomes disconnected.
The “CLOCK ADJ” will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1 to step 4.
To change the 24-hour or 12-hour display:
Summer time:
1
Press and hold down the CLOCK button on the main unit or
remote control for more than 2 seconds.
2
Press the or button to select 12-hour or 24-hour
display and then press the CLOCK button.
The 24-hour display will appear.
(0:00 - 23:59)
The 12-hour display will appear.
(12:00 AM - 11:59 PM)
3
Press the or button to adjust the hour and then
press the CLOCK button.
Press the or button once to advance the time by 1 hour.
Hold it down to advance continuously.
FU NC TIO N C LO C K
S LEEP TI M ER
SN OOZE/
DI MM ER
VOL
M E M ORY DI S PLAY
PLAY
M ODE
E S OU N D
/DE M O
FOLDER
C LO C K
MUSIC SYSTEM
DK-UH2
SN
OO
ZE /D
IM
ME
R
ON/S
TAND-BY
VO L
-
VO
L
+
CL
OC
K
E S
OU ND
/D
EM
O
4
4
7
6
4
Press the or button to adjust the minutes and then
press the CLOCK button.
Press the or button once to advance the time by
1 minute. Hold it down to change the time in 5-minutes interval.
1 Clear all the programmed contents. [Refer to “Factory reset,
clearing all memory” on page 19 for details.]
2 Perform “Setting the clock” from step 1.
1 Press the button at remote control to advance the time
1 hour. indicator will appear on display.
2 Press the button again to turn the clock back 1 hour.
“12:00 AM”
“0:00”