Sharp CP-DAB1H, Operation Manual

Page: 12 / 18

E-11
Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00)
display.
Press the ON/STAND-BY button to turn to stand-by
mode.
Press and hold the CLOCK/TIMER button until “00:00”
appear.
Within 10 seconds, press the or button to adjust
the hour and then press the MEMORY button. Press
the
or button once to advance the time by 1
hour. Hold it down to advance continuously.
Press the or button to adjust the minutes and
then press the MEMORY button. Press the or
button once to advance the time by 1 minute. Hold it
down to advance continuously.
To confi rm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
The “00:00” will appear when the AC power supply is
restored after a power failure or unplugging the unit. If
incorrect, readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.
1
2
3
4
Timer and sleep operation (Remote
control only)
Timer playback:
The unit turns on and plays the desired source (CD, USB,
TUNER, DAB or AUDIO IN) at a preset time.
Timer playback
■
Before setting timer:
Check that the clock is set to the correct time (refer
to the column on the left). If it is not set, you cannot
use the timer function.
For timer playback, load the disc to be played back.
1
2
Press the ON/STAND-BY button to turn the power on.
Press the CLOCK/TIMER button for about 2 seconds.
Within 10 seconds, press the or button to select
“ONCE” or “DAILY” and then press the MEMORY
button.
Press the or button to adjust the hours for timer
on and then press the MEMORY button.
Press the or button to adjust the minutes for
timer on and then press the MEMORY button.
Press the or button to adjust the timer off (as in
step 4 and 5) and then press the MEMORY button.
To select the timer playback source (CD, TUNER, USB
or AUDIO IN), press the
or button. Press the
MEMORY button.
When you select TUNER, select a station by pressing
the
or button, and then press the MEMORY
button. If a station has not been programmed, “NO
P-SET” will be displayed and timer setting will be
canceled.
1
2
3
4
5
6
7
XL-DAB1H_AUS (A5).indd 11 XL-DAB1H_AUS (A5).indd 11 6/21/2010 9:12:55 AM 6/21/2010 9:12:55 AM