Sharp CD-SW440NH, Operation Manual

Page: 15 / 34

04/1/28 CD-SW440N_09 EN
E-6
9
1
7
6
5
4
3
2
1
System connections (continued)
●
The first time the unit is plugged in, the unit will enter
the demonstration mode. You will see words scroll and
the subwoofer and front speakers will light-up in
flashing mode.
●
To cancel the demonstration mode, press the DEMO
button (remote control) during power stand-by mode.
The unit will enter the low power consumption mode.
The subwoofer and front speaker light up will be off.
●
To return to the demonstration mode, press the DEMO
button again.
The iPod with photo and video can be viewed by
connecting to a TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket on the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL
to match your TV signal. Please visit Apple’s homepage for
further information.
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket If you plug in the unit first, the unit will enter the
stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
Remote control
Remote control (continued)
Caution:
●
Replace all old batteries with new ones at the same
time.
●
Do not mix old and new batteries.
●
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
●
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
●
Installing the batteries incorrectly may cause the unit to
malfunction.
●
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.
Notes concerning use:
●
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic. Purchase
2 “AAA” size batteries (UM/SUM-4, R3, HP-16 or
similar).
●
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
●
Keep the remote control away from moisture, heat,
shock and vibrations.
Check the remote control after checking all the
connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:
1 Open the battery cover.
2 Insert the batteries according to the direction indicated
in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3 Close the cover.
Demonstration mode
Connecting iPod to a TV
AC power connection
Battery installation
Test of the remote control
FUNCTION FUNCTION
AUDIO IN AUDIO IN
PHONE S PHONE S
VOL VOL
ON/ S TAND-BY ON/ S TAND-BY
PU S H PU S H
OPEN OPEN
M I N I C O M P O N E N T S Y S T E M
CD- S W440
0.2 m - 6 m
(8" - 20')
Remote sensor