26/4/05
CD-SW200H(H)_EN.fm
E-40
CD-SW200H
TINSZA165AWZZ
8
1
2
3
4
5
6
7
ENGLISH
References
Headphones
z
Before plugging in or unplugging the headphones, reduce the
volume.
z
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended imped-
ance is 32 ohms.
z
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
CD player
Symptom
Possible cause
z
The clock is not set to the
correct time.
z
Did a power failure occur? Reset
the clock. (Refer to page 12.)
z
When a button is pressed,
the unit does not respond.
z
Set the unit to the power stand-
by mode and then turn it back on.
z
If the unit still malfunctions, reset
it. (Refer to page 42.)
z
No sound is heard.
z
Is the volume level set to "0"?
z
Are the headphones connected?
z
Are the speaker wires discon-
nected?
Symptom
Possible cause
z
Playback does not start.
z
Is the disc loaded upside down?
z
Playback stops in the mid-
dle or is not performed
properly.
z
Does the disc satisfy the stan-
dards?
z
Is the disc distorted or
scratched?
z
Playback sounds are
skipped, or stopped in the
middle of a track.
z
Is the unit located near excessive
vibrations?
z
Is the disc very dirty?
z
Has condensation formed inside
the unit?
