Sharp CD-RW5000, Service Manual

Page: 5 / 80

– 5 –
CD-RW5000
OPERATION MANUAL
To confirm the time display in the stand-by mode:
Press the DISPLAY button on the remote control. The time display will appear for
about 3 seconds.
Note:
“CLOCK” will appear or time will flash at the push of the DISPLAY button when the AC
power supply is restored after a power failure or after unplugging the unit.
Reset the clock as follows.
To reset the clock:
Perform “Setting the Clock” from the beginning.
At this time, step 5 (for selecting the 12-hour or 24-hour display) will be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to “If trouble occurs (reset)” on page 44 for details.]
2.
Perform “Setting the Clock” from the beginning.
Setting the Clock
In this example, the clock is set for the 12-hour (AM12:00) display.
1
Press the POWER button to turn the power on.
2
Press the MENU button.
3
Turn the jog dial to select “CLOCK” and within 10 seconds, press
the ENTER button.
4
Within 2 minutes, press the ENTER button again.
5
Turn the jog dial to select the 12-hour or 24-hour display and
within 2 minutes, press the ENTER button.
6
Turn the jog dial to adjust the hour and within 2 minutes, press
the ENTER button.
● When the 12-hour display is selected, “AM” will change automatically to “PM”.
7
Turn the jog dial to adjust the minutes and within 2 minutes, press
the ENTER button.
● The hour will not advance even if minutes advance from “59” to “00”.
● The clock starts from “0” second. (Seconds are not displayed.)
The time display will disappear after a few seconds.
“AM 12:00”
→
The 12-hour display will appear. (AM 12:00 - PM 11:59)
“AM 0:00”
→
The 12-hour display will appear. (AM 0:00 - PM 11:59)
“0:00”
→
The 24-hour display will appear. (0:00 - 23:59)
■ Test of the remote control
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the POWER button. Does the power turn on? Now, you can enjoy the music.
8" - 20'
(0.2 m - 6 m)
Remote Control
Remote sensor
Troubleshooting Chart (continued)
■ If trouble occurs (reset)
When this product is subjected to strong external interference (mechanical shock, ex-
cessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is oper-
ated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1. Press the POWER button to enter the power stand-by mode.
2. While pressing down the VOLUME
button, press the POWER button un-
til “ALL CLEAR” appears.
Caution:
This operation will erase all data stored in memory including clock and timer settings,
and tuner and CD presets.
■ Before transporting the unit
Remove the CD-R/CD-RW disc and all CDs from the unit. Your unit checks whether
there are any discs inside the unit when the tray is closed. “CDR NO DISC” and “CD
NO DISC” appear if no disc is left. Then, set the unit to the power stand-by mode.
Carrying the unit with discs left inside can damage it.
and