A37159,SEC R90GC O/M
3
TINSEA986WRRZ-D31 SEC R90GC
Door hinges
Safety door latches
Waveguide cover
Door seals and sealing surfaces
Unpacking and Examining Your Oven
Remove:
1. all packing materials from inside the oven cav-
ity; however, DO NOT REMOVE THE
WAVEGUIDE COVER, which is located on the
right cavity wall. Read enclosures and SAVE
the Operation Manual, Sharp High Speed Con-
vection Microwave Oven Cookbook and Touch
Guide.
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
Choosing a Location for Your Oven
You will use your oven frequently so plan its lo-
cation for ease of use. The oven must be placed
on a countertop which is a minimum of 36 inches
from the floor. Allow at least 2 inches on the sides,
top and at the rear of the oven for air circulation.
Be sure to position oven so that the rear cannot
be touched inadvertently.
Your oven can be built into a cabinet or wall by
itself or above a specific electric wall oven using
Sharp's Built-in Kit listed below. It cannot be built
in above conventional gas or electric ranges or
any other wall ovens.
Note for Sharp's Built-in kits:
Select the Built-in kit RK-90S27 or RK-90S30
depending on the desired finished width. The RK-
90S27 is for a 27 inch and the RK-90S30 is for a
30 inch finished width.
See Sketch 1 for proper location when building in
above the specified wall ovens. Carefully follow
both the wall oven installation instructions and
Sharp's Built-in Kit instructions. Be sure that the
clearance of the floor between the wall oven and
the high speed oven is minimum of 2 inches.
Ordering the Built-in Kit.
If your dealer does not stock the kit, it can be or-
dered directly from the Sharp Accessories and
Supplies Center. Have your credit card number
available and call toll-free: 1-800-642-2122 for
ordering the kit to be sent to your address. The kit
includes ducts and finish trim strips and easy-to-
follow instructions for installation as well as the
location of the power supply.
2. the feature sticker, if there is one, from the out-
side of the door.
Check the oven for any damage, such as mis-
aligned or bent door, damaged door seals and
sealing surfaces, broken or loose door hinges
and latches and dents inside the cavity or on
the door. If there is any damage, do not oper-
ate the oven and contact your dealer or SHARP
AUTHORIZED SERVICER.
Sketch-1
MIN.
2"
Electric Wall
Oven.
MIN.
36"
Sharp's
Built-in kits
Applicable
Electric
Wall Ovens
G.E.
JTP18S0D1SS
DCS
DCS-WO-130SS
VIKING
VESO105SS
DCS
DCS-WO-127SS
VIKING
VESO176SS
RK-90S30
RK-90S27
SEC R90GC O/M,P01-10
03.5.12, 6:05 PM
3