36
OVEN LIGHT
Remove the louver per instructions 1-3 above and
charcoal filter, if used.
1. To replace light bulb, first disconnect power to the
oven at the circuit breaker panel or by unplugging.
2. Open light cover located behind filter mounting by
carefully pulling up on the front edge.
R E P L A C I N G P A R T S
WORK LIGHT AND
NIGHT LIGHT
1. To replace light bulbs, first disconnect power to
the oven at the circuit breaker panel or by
unplugging.
2. To release cover, remove the screw on the light
cover. (See illustration.)
3. Replace light bulbs with equivalent watt bulb
available from your Sharp Authorized Servicer or
parts distributor. Bulbs are also available at most
hardware stores or lighting centers. DO NOT USE
A BULB LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed
in step 2.
CAUTION:
Light cover may become very hot. Do not
touch glass when light is on.
CHARCOAL FILTER
Charcoal Filter, Sharp Part number RK-230 which
was enclosed with your oven, is used for nonvented,
recirculated installation. The filter should be changed
every 6 to 12 months depending on use. See page 6
for ordering information.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove center screw from the top center of the
louver and push down carefully on the tab at each
end of the louver to disengage.
3. Pull the louver away from the unit.
4. Change the charcoal filter.
5. To replace, insert the top tabs of hood louver into
the 3 openings on the cavity faceplate holding
louver at a slightly outward tilt. Rotate louver so
the top tabs are positoned in the cavity faceplate
openings. Push in the bottom of louver to ensure
that the three bottom clips snap into the cavity
faceplate. Check for proper engagement and replace
the screw removed in step 2.
3. Remove old light bulb and replace only with
equivalent watt bulb available from a Sharp
Authorized Servicer or parts distributor. Bulbs are
also available at most hardware stores or lighting
centers. DO NOT USE BULB LARGER THAN
30 WATTS.
4. Replace the oven light cover by carefully pushing
into place. Replace the charcoal filter, if used. Push
the louver back into place and replace the louver
mounting screw.
Oven light
Hood louver
Charcoal
filter
Screw
Bottom clips
Top tabs
Cavity
faceplate
Light cover
Screw
Light bulbs
Summary of Contents for Carousel R-1750
Page 1: ......
