8-17
CHAPTER
8
KEY OPERATOR PROGRAMS
Initial Status Setting
The copier will assume the initial settings when it is turned on, when
the CLEAR ALL (
CA
) key is pressed, or when the auto clear interval
has elapsed after a copy run. Use this program to establish the initial
settings.
When the “INITIAL STATUS SETTING.” key is pressed, the following
display will appear.
To establish new initial settings
1.
Press the “ESTABLISH NEW INITIAL SETTINGS.” key.
2.
Select all initial settings on the operation panel.
●
The following functions cannot be set:
Number of copies, XY zoom, automatic copy ratio selection,
interrupt, special functions, information, stapling position (for an
optional finisher (AR-FN1)) and LCD contrast.
3.
Press the “OK” key.
To return to the factory default settings
Press the “RETURN TO THE FACTORY DEFAULT SETTINGS.”
key.
Stream Feeding Mode
This program is used to enable the stream feeding mode of the
document feeder. When the stream feeding mode is enabled, additional
originals which are set in the document feeder tray within 5 seconds
after the previous original was fed will be fed and copied automatically.
To enable the stream feeding mode, press the check box of
“STREAM FEEDING MODE.” to display a check mark in the
check box.
To disable this mode, press the check box of this program
again to clear the check mark in the check box.
●
The stream feeding mode will only function when the group mode has
been selected.
KEY OPERATOR PROGRAMS
INITIAL STATUS SETTING.
SET THE INITIAL STATUS.
ESTABLISH NEW INITIAL
SETTINGS.
RETURN TO THE FACTORY DEFAULT
SETTINGS.
OK
1/4
1/4
KEY OPERATOR’S GUIDE
Key operator programs
Summary of Contents for AR-280
Page 14: ......
Page 110: ......
Page 166: ......
Page 168: ...AR 280 AR 285 AR 335 PRINTED IN JAPAN 98F KS TINSE1697FCZZ SHARP CORPORATION ...
