12
Preparation
The remote control unit has been pre-paired with the
TV set in factory so you can use the remote control
unit directly. If the remote control fails to operate or
a new remote control unit is used, please follow the
following steps to pair the remote control unit and the
TV.
Remote control pairing
You can also setup the TV through the operation
button at the TV back. (The position of the operation
button, please see page 10)
The operation button
Action
Description
Short press
Turn on the TV.
Left/Right
Set the volume
reduction/add.
Up/Down
Set the channel up/down.
Long press
Display the menu( Pairing , Power off )
when the TV is switched on.
NOTE
•
If the TV does not display the remote control pairing
information, the "Pairing" Interface will be displayed
automatically. Press
OK
& (
POWER
) on the remote
control unit at the same time, the red and blue lights
flash alternately. Once the flashing stop, press
OK
to
complete the Bluetooth pairing.
•
If pairing is not succeed, please try again or contact the
customer service center.
Press the " " button on the TV for a few
seconds, "Pairing "and "Power off" menu will
be displayed.
1
Point the remote control unit towards the
bottom left corner of TV (within 20cm),
press
"
OK
" and " " at the same time until red and
blue lights stop flashing alternately .
Press "
OK
" on the remote control unit to
complete the Bluetooth pairing .
3
4
2
Use the operation button on the TV to choose
"Pairing" and then press the TV operation
button.
The mouse function of the remote control
With the built-in gyroscope sensor, setup the TV
through motion sensing of the remote control .
With the mouse function, you can move the cursor
of the screen to selected item and press
OK
to enter
when browsering the smart home.
•
When the remote control is in dormancy,
the remote
control to restart it.
