Quick guide
Initial auto installation
When the TV is powered on for the first time after
purchase, the initial auto installation wizard appears.
Follow the menus and make the necessary settings
one after another.
Press
a
on the TV.
The initial auto installation wizard appears.
Setting the OSD language.
English
Italiano
Svenska
Press
a
/
b
/
c
/
d
to select the desired language,
and then press
OK
.
Selecting the location of the TV.
STORE
HOME
Press
c
/
d
to select where you will use this TV,
and then press
OK
.
HOME: “STANDARD” will be the default value for the “AV
MODE” setting.
STORE: “DYNAMIC (Fixed)” will be the default value for the
“AV MODE” setting. If the “AV MODE” is changed, the TV will
automatically switch back to “DYNAMIC (Fixed)” when there
is no signal input from the TV or remote control unit for 30
minutes.
Setting the country.
Austria A B/G
Finland FIN B/G
Greece GR
B/G
Press
a
/
b
/
c
/
d
to select your country or area,
and then press
OK
.
This setting screen only appears during the first installation.
Starting channel search.
Analogue Search
Digital Search
Press
c
/
d
to select “Digital Search” or “Analogue
Search”, and then press
OK
.
If you want to search for more broadcasts, execute
“Additional Search” from the “Programme Setup” menu
(Pages 27 and 28).
To watch both analogue broadcasts and digital broadcasts,
you should perform the channel search setting for each
format.
EXAMPLE
If you execute “Digital Search” in the initial auto installation
wizard, you should perform “Analogue Search” from “Auto
Installation” under the “Setup” menu (Pages 27 and 28).
1
•
2
3
•
•
4
•
5
•
•
•
The TV searches for, sorts and stores all the
receivable TV stations according to their settings
and the connected antenna.
To abort the initial auto installation in progress, press
6
.
NOTE
If you turn off the power on the TV after performing step 5,
the initial auto installation wizard does not appear. The auto
installation function allows you to execute the installation
again from the “Setup” menu (Page 27).
The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 6.
Checking signal strength and
channel strength
If you install a DVB-T antenna for the first time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
Press
MENU
and the “MENU” screen displays.
Press
c
/
d
to select “Setup”.
Press
a
/
b
to select “Antenna Setup-DIGITAL”,
and then press
OK
.
Checking signal strength
Press
a
/
b
to select “Signal Strength”.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current Max
0
CH No.
21
0
Current Max
0 0
Checking channel strength
Press
a
/
b
to select “Channel Strength”, and
then press
OK
.
You can input a specified frequency band using the
0
–
9
numeric buttons.
Signal Strength
Supply Voltage
Channel Strength
Signal Strength
Quality
Current
Max
0
CH No.
21
0
Current
Max
0
0
4
7
4
.
0
MHz
Position and align the antenna so that the
maximum possible values for “Signal Strength”
and “Quality” are obtained.
NOTE
The values of “Signal Strength” and “Quality” indicate when
to check the appropriate alignment of the antenna.
6
•
•
•
1
2
3
E
E
•
4
•
9
Confirm the following before turning
on the power
Is the antenna cable connected?
Is the AC cord plugged in?
E
E
