Sharp AQUOS LC-26GA5H, Service Manual

Page: 26 / 167

26
LC-26GA5H/M/X
(2) List of adjustment commands
RS-232C commands are used for adjustments. Here are the adjustment commands at a glance.
Item Command Description
1 Two-point MSET0000
adjustment start
2 Adjustment MSET0004
initialization
3 Adjustment MSET0003
value storage
4 Low-level SDML0070
adjustment
point setting
5 Low-level R MGLR X X X X
adjustment
6 Low-level G MGLG X X X X
adjustment
7 Low-level B MGLB X X X X
adjustment
8 High-level SDMH0187
adjustment point
setting
9 High-level R MGHR X X X X
adjustment
White balance (two-point) adjustment started.
All commands after this command is accepted are for two-point
adjustments.
Adjustment values initialized.
The adjustment value buffer in the set gets initialized.
Adjustment values stored.
Command-adjusted parameters are stored on EEPROM.
Low-level adjustment points preset.
Parameter zone: 0 thru 255
Parameter-specified gradation patterns after this command are displayed.
Parameter-specified adjustment values are default after initialization
(Same as RGB setting). Initialized commands include MGLR, MGLG and
MGLB. Initial settings: 192 for MGLR/G/B initial value at SDML0048, for
example.
Low-level R gamma point adjusted.
Parameter zone: 0 thru 1023
With this command, the adjustment pattern's R level is set as its parameter
value. The parameter value is written in the adjustment value buffer of the
set.
Low-level G gamma point adjusted.
Parameter zone: 0 thru 1023
With this command, the adjustment pattern's G level is set as its parameter
value. The parameter value is written in the adjustment value buffer of the
set.
Low-level B gamma point adjusted.
Parameter zone: 0 thru 1023
With this command, the adjustment pattern's B level is set as its parameter
value. The parameter value is written in the adjustment value buffer of the
set.
High-level adjustment points preset.
Parameter zone: 0 thru 255
Parameter-specified gradation patterns after this command are displayed.
Parameter-specified adjustment values are default after initialization
(Same as RGB setting). Initialized commands include MGHR, MGHG and
MGHB. Initial settings: 800 for MGHR/G/B initial value at SDMH0200, for
example.
High-level R gamma point adjusted.
Parameter zone: 0 thru 1023
With this command, the adjustment pattern's R level is set as its parameter
value. The parameter value is written in the adjustment value buffer of the
set.