AL-2040CS SIMULATION, TROUBLE CODES 10 - 7
26
42
Transfer ON timing control setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed. (For any number different from the
following ones, the default time is automatically set.)
43
Side void setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number of the side void amount is displayed.
2. Enter the code number and press the start key. The setting is changed.
62
Energy-save mode copy lamp setup
Used to set half-ON (50%)/OFF of the copy lamp in the pre-heat mode.
When this simulation is executed, the current setup of the code number is displayed. Enter the code number and press the
PRINT switch to enable the setup.
30
01
Paper sensor status display
Indicates the paper sensor status using the lamps on the operation panel.
41
06
OC cover float detection level adjustment
When this simulation is executed, the current set value is displayed.
When ENTER/START key is pressed, the mirror base unit moves to the SPF scanning position and the OC cover float
detection level (number of pixels between black lines) is acquired and displayed.
The value (0000) is displayed on the 7seg in 2 digits for each.
When the mirror base unit returns to the home position, the acquired value is displayed.
If the value is not acquired, an error is displayed as shown below. (Default: 0)
The status display is as shown below.
The JAM lamp is lighted. (The 7seg display remains to the original value.)
Note that the OC cover must be closed when executing this simulation.
∗
When the value is 0, float detection is not performed in a normal job.
When C key is pressed, the display returns to the sub code input standby state.
Main
code
Sub
code
Content
Code number
Setting
0
Default (236 msec)
1
– 20 msec
2
– 18 msec
3
– 16 msec
4
– 14 msec
5
– 12 msec
6
– 10 msec
7
– 8 msec
8
– 6 msec
9
– 4 msec
10
– 2 msec
Code number
Setting
11
Default (236 msec)
12
+2 msec
13
+4 msec
14
+6 msec
15
+8 msec
16
+10 msec
17
+12 msec
18
+14 msec
19
+16 msec
20
+18 msec
21
+20 msec
Code number
Setting
0
0 mm
1
0.5 mm
2
1.0 mm
3
1.5 mm
4
2.0 mm * Default
5
2.5 mm
6
3.0 mm
7
3.5 mm
8
4.0 mm
9
4.5 mm
10
5.0 mm
Code number
Setup
0
Copy lamp OFF
1
Copy lamp half-ON (50%) * Default
Sensor name
Display lamp
Before-resist paper sensor (PPD1)
Developer cartridge replacement lamp
Fusing section paper sensor (PPD2)
JAM lamp
Paper exit sensor (POD)
Photoconductor cartridge replacement lamp
2nd CS paper sensor (PPD3)
2nd cassette lamp
New drum cartridge sensor (PUIS)
Zoom lamp
Summary of Contents for AL-2030
Page 105: ......