Sharp AF-W12CME, Operation Manual

Page: 18 / 20

18
Fig.13
Front panel
back view
(3)
(1)
(2)
5
Slide the chassis back into the
cabinet. (Fig. 10)
Replace the front panel. (Fig.12)
Slide the crank shaft into the open-
ing of the louver link at the back of
the front panel. (Fig.13)
(4)
Fig.10
Fig.11
Chassis
Angle
Slit Cabinet
Louver link
Crank shaft
Front panel
Fig.12
Grille
Fig.14
Front panel
Secure the chassis to the cabinet
using the screw and angle removed
in step 2. Push the angle into the
gap between the chassis and the
cabinet. Hook the angle to the slit
of the cabinet, next screw it on to
the chassis. (Fig. 11)
Open the grille and secure the front
panel with the screw removed in
step 1 (Fig.14). Replace the air
filter and close the grille firmly.
At this step, make sure the cabinet is
inclined approximately 1cm (3/8") to
the back (Fig.9).
If the cabinet is not properly inclined,
the water collected in the bottom tray
during operation will not drain properly
and may flow into the room where the
air conditioner is installed.
(3)
Cut the gasket to an appropriate
length and stuff it into the gap
around the mounting frame and
the unit to seal outside air. (Fig.8)
WARNING:
cabinet
mounting
frame
incline backwards about 1cm
(3/8")
Fig.9
INSTALLATION
Scratching screw for
grounding.
Serration