9
Operation of wireless remote control con’t.
Changing batteries and notices
(1)
Slightly press down and push the back cover of wireless
remote controller. (As show in Fig 1.)
(2
) Take out the old batteries.
(3)
Insert two new AAA1.5V dry batteries, and pay attention to the
polarity. (As shown in Fig 2.)
(4)
Attached the back cover of wireless remote controller
NOTE:
●
When changing the batteries, do not use the old or different
batteries, otherwise, it can cause the wireless remote controller to
malfunction.
●
If the wireless remote controller will not be used for a long time,
please take batteries out, so leakage will not damage the wireless
remote controller.
●
The remote controller should be placed 1m away from the TV set
or stereo sound sets.
The operation should be in its receiving range.
●
If the remote control cannot operate normally, please take the
batteries out, and then reinsert it 30s later; if it is also abnormal,
please replace the batteries.
●
If the main unit needs to be remote controlled, please aim
remote controller at the receiver of main unit in order to improve
the receiving sensitivity of the main unit.
●
When the remote controller sends out signal, a mark
will flicker for about 1s. The bell will ring if the
main unit receives effective signal.
Emergency Operation
When the wireless remote control is lost or damaged, please use the manual switch on the main unit.
Operation will be in Auto Run mode and the temperature setting or fan speed cannot be changed.
The manual switch can be operated as follows:
●
To operate: Press the AUTO button and the unit will enter into AUTO RUN mode. The microcomputer will
monitor the room temperature to select the (COOL, HEAT, FAN) mode automatically, to obtain the
comfortable effect.
●
To turn off: Press the AUTO button to switch the unit off.
AUTO
