Test Equipment Connections:
Refer to Figure
OSCILLOSCOPE . . . . . .
GENERAL
Connect to
through “Video
. . . . . . . . Connect AC power plug through the
Detector Test Block” shown in Figure
isolation transformer to power supply.
SWEEP GENERATOR . . . . . . . . . . . Connect the IF Video
Set Channel selector to the highest unused channel.
put through the Out Put Pad. (Refer to Figure
Preset
control to approximately midposition.
MARKER GENERATOR . . . . . . . . Connect as shown.
Set the Contrast control to maximum. Connect a
SIGNAL GENERATOR . . . . . . . . . . . . Connect as shown Produce
short clip lead between
and
of
signal.
BIAS SUPPLY . . . . . . . . . . . Apply
volts bias to
RF MODULATOR . . . . . . . . . . . . . . . . . . Connect as shown.
OUT PUT PAD . . . . . . . . . . . . . . . . . . . . . . . . . Connect as shown.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Check to bias voltage.
STEP
ADJUSTMENT
SWEEP
MARKER
GENERATOR
GENERATOR
COMPONENT
PROCEDURE
1
Set the
control to
of its range.
2
Apply output of Sweep Generator to the RF
Set the
control to the
of it range.
3
Apply
bias to
4
Trans.
Alignment
Summary of Contents for 8C221
