420 774 335 397 www.sharks-shop.cz
Stránka 27
● The air which is sucked in by the compressor must be kept free of impurities that could cause fires
or explosions in the compressor pump.
● When releasing the hose coupling, hold the hose coupling piece with your hand. This way, you can
protect yourself against injury from the rebounding hose.
● Wear safety goggles when working with the blowout pistol. Foreign bodies or blown off parts can
easily cause injuries.
● Do not blow at people with the blow-out pistol and do not clean clothes while being worn. Risk of
injury!
SAFETY INFORMATION FOR PAINT SPRAYING
● Do not process any paints or solvents with a flash pint below 55°C. There is a risk of explosion!
● Do not heat up paints or solvents. There is a risk of explosion!
● If hazardous liquids are processed, wear protective filter units (face guards). Also, adhere to the
safety information provided by the manufacturers of such liquids.
● The details and designations of the Ordinance on Hazardous Substances, which are displayed on
the outer packaging of the processed material, must be observed.
● Additional protective measures are to be undertaken if necessary, particularly the wearing of suitable
clothing and masks.
● Do not smoke during the spraying process and/or in the work area. There is a risk of explosion!
Paint vapors are easily combustible.
● Never set up or operate the equipment in the vicinity of a fire place, open lights or sparkling
machines.
● Do not store or eat food and drink in the work area. Paint vapors are harmful to your health.
● The work area must exceed 30 m
3
and sufficient centilation must be ensured during spraying and
drying. Do not spray against the wind. Always adhere to the regulations of the local police authority
when spraying combustible or hazardous materials.
● Do not process media such as white spirit, butyl alcohol and methylene chloride with the PVC
pressure hose. These media will destroy the pressure hose.
BEFORE STARTING THE EQUIPMENT
Before you connect the equipment to the mains supply make sure that the data on the rating plate are
identical to the mains data.
● Check the equipment for damage which may have occured in transit. Report any damage
immediately to the transport company which was used to delivet the compressor.
● Install the compressor near the point of consumption.
● Avoid long air lines and supply lines (extension cables).
● Make sure that the intake air is dry and dustfree.
● Do not install the compressor in a damp or wet room.
● The compressor may only be used in suitable rooms (with good ventilation and an ambient
temperature from +5°C to 40°C). There must be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
● The compressor is designed to be used in dry rooms. It is prohibited to use the compressor in areas
where work is conducted with sprayed water.
ATTACHMENT AND OPERATION
Important!
You must fully assemble the appliance before using it for the first time!
Mains connection
● The compressor is equipped with a mains cable with shock-proof plug. This can be connected to any
230V/50Hz shock-proof socket which is protected by a 16A fuse.
● Before you use the machine, make sure thaqt the mains voltage is the same as the operating
voltage (see the rating plate).
● Long supply cables, extensions, cable reels etc. Cause a drop in voltage and can impede motor start
up.
● At low temperatures below +5°C´, sluggishness may make starting difficult or impossible.
