420 774 335 397 www.sharks-shop.cz
Stránka 45
2.
Put the switch to “I” position.
3. While holding the throttle lever together with the throttle interlock, push in the side throttle lock
button and release the throttle lever to hold it at the starting position.
4. Pull out the choke knob to the closed position.
NOTE
When restarting immediately after stopping the engine, leave the choke knob at the open position.
5. While holding the saw unit securely on the ground, pull the starter rope vigorously.
WARNING
Do not start the engine while hanging the chain saw with a hand.
The saw chain may touch your body. It’s very dangerous.
6. When engine has ignited first push in the choke knob and pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle lever pulled slightly.
WARNING
Keep clear of the saw chain as it will start rotating upon starting of engine.
CHECKING OIL SUPPLY
WARNING!
Make sure to set up the bar and the chain when checking the oil supply . If not the rotating
parts may be exposed. Is is very dangerous.
After starting the engine, run the chain at medium speed
and see if chain oil is scattered off as shown in the figure
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions.
NOTE
: The chain oil tank should become nearly
empty by the time fuel is used up. Be sure to refill the
oil tank every time when refueling the unit.
ADJUSTING CARBURETOR
(1) L needle
(2) H needle
(3) Idle adjusting screw
The carburetor on your unit has been factory adjusted, but may
require fine tuning due to change in operating conditions. Before
adjusting the carburetor, make sure that provided are clean air/fuel
filters and fresh, properly mixed fuel.
