Shark S3502 Series, Owner'S Manual

Page: 8 / 20

4 TOLL FREE: 1-800-798-7398
IMPORTANT: First things first, always make sure
the mop is
UNPLUGGED
from the wall when not
in use. Never fill the mop, attach the mop head,
change or remove the cleaning pocket when the
mop is plugged into the wall. If you have hard water
you might want to use distilled water to prolong
the life of the Shark
® Steam Mop. Make sure you
only add water to the tank. Chemicals or cleaning
solution may damage the appliance and could be
unsafe for you and your family.
3
Snap the mop head into the base to secure it.
IMPORTANT: Don’t use on unsealed wood or
unglazed ceramic floors. On surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area
of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.
1
Turn the water tank cap counter clockwise and
remove from the tank.
Use the filling flask and pour water into the tank.
Please don’t overfill. Replace the cap on the water
tank by turning clockwise and tightening.
2
Select a mop head and cleaning pad. Each mop
head can be used on your floors. The Triangle
Mop Head was specifically designed to reach into
those tight corners and spaces, especially those
found in the bathroom. The Rectangle Mop Head is
completely versatile. Use the lavender loop on the
side of the cleaning pocket to place around the mop
head. Then attach the quick fasteners on the top of
the pocket to secure in place. You can also use the
loop to pull the dirty pocket off when you are done
mopping after it has cooled.
1
Getting Started - cont’d
2
3