4
5
ste
am
con
tro
l
IMPORTANT:
Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
Getting Started - cont’d
IMPORTANT:
Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area
of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.
2
Select the All-Purpose Mop Head and accompanying
cleaning pocket. Use the loop on the side of the
cleaning pocket to slide the mop head into the
cleaning pocket. Then secure the quick fasteners on
the top of the pocket to lock in place.
(fig. 2)
3
Snap the mop head into the base to secure it.
(fig. 3)
4
Open the water tank door.
(fig. 4)
Use the filling flask and pour water into the tank. Do
not overfill. Press the water tank door firmly to close.
(fig. 5)
1
Pull and twist the quick release cord holder to unwrap
the power cord completely. Plug into an electrical
outlet.
(fig. 6)
2
The
STEAM CONTROL
button will flash blue. If the
light does not turn on, reference the troubleshooting
section on page 9.
(fig. 7)
IMPORTANT:
Do not use the mop without attaching
a cleaning pocket and adding water to the tank first.
When you are using the mop for the first time, it
might take longer than the normal 30 seconds to
start steaming.
Using Your Steam Mop
fig. 3
fig. 6
fig. 7
fig. 4
fig. 5
fig. 2
