6
7
ste
am
con
tro
l
Using Your Steam Mop - cont’d
3
Press the
STEAM CONTROL
button
once to activate the
LOW
steam setting.
Press the
STEAM CONTROL
button twice to activate
the
HIGH
steam setting.
(fig. 8)
4
Clean your floors with a forward and backward
motion.
(fig. 9)
To stop the steam, press the
STEAM CONTROL
button a third time.
The
STEAM CONTROL
button will flash blue to
indicate the mop is in
STANDBY
mode.
fig. 8
fig. 9
5
When one side of the cleaning pocket gets dirty, just
flip the mop and you can quickly start using the other
side.
(fig. 10)
6
When the water tank is empty, the steam mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from the
outlet. Reference the filling instructions from page 4.
NOTE:
Please wait 2-3 minutes for the Steam Mop
to cool off before removing the mop head or the
cleaning pocket. Never leave the steam mop with a
damp/wet cleaning pocket on any floor.
fig. 10
2
Empty the water tank before storage. Open the water
tank door and empty the tank over a sink. Close the
water cap.
(fig. 12)
3
To store the Shark
®
Slim Professional Steam Pocket
®
Mop hanging up, first remove the head (after it has
cooled and the steam has been released) then hang
on a large hook.
(fig. 13)
AFTER USE AND STORAGE
1
When you have finished using the steam mop,
press the
STEAM CONTROL
button until the LED
light turns flashing
BLUE
. This stops the unit from
steaming. Unplug the cord from the outlet and place
the mop into the upright position. Let the unit cool for
2-3 minutes.
Remove the cleaning pocket by releasing the quick
fasteners and using the lavender loop on the side of
the pocket, avoiding contact with the hot pocket or
dirt.
(fig. 11)
Care of Your Steam Mop
fig. 11
fig. 12
fig. 13
