13
www.sharkclean.com
English
Using Your Press & Refresh
™
- cont.
Care of Your Press & Refresh
™
Troubleshooting Guide
Cleaning & storing
1
Turn the garment steamer off
“O”.
2
Unplug the appliance from the
electrical outlet.
3
Let the appliance cool
completely for approximately
30 minutes.
4
Empty the water from the
water tank.
5
Wipe the exterior of the
garment steamer with a damp
cloth and wipe dry if needed.
9
Hand wash the bonnet frame
in cold water with a mild
detergent and let air dry
completely before using again.
Do not dry in clothes dryer.
10
To re-attach the frame, gently
snap the frame over the steam
nozzle and press gently to lock
into place (
Fig. 1
).
PROBLEM
POSSIBLE REASONS
SOLUTIONS
There is no
steam.
The steamer is not turned on.
There is not enough
water in the unit.
Verify that the blue light on the unit is lit. If not,
check that the unit is plugged in and the on/off
button is raised and in the on “I” position.
Verify that the water tank is at least half way full
or fill to the max fill line.
The nozzle leaves
water drops on the
garment.
You are not using the steam
bonnet.
The steam bonnet is
too wet.
The frame has condensation.
The small steam bonnet frame must be in place
at all times during usage.
The bonnet prevents water drops being left on
the garment and to removes impurities from your
water.
Let the unit cool for 30 minutes, remove the
steam bonnet and let it dry out before using
again or replace with a new bonnet frame.
Let the appliance cool and wipe the frame off.
6
Bundle up the power cord and
secure it with the VELCRO
®
strap that is attached to the
power cord. Always store your
appliance in a cool, dry area.
Care & use of the small steam
bonnet frame
7
The steam bonnet is attached
to a frame and helps filter
impurities from your water.
It might become slightly
discolored over time.
8
Let the steamer cool completely
before removing. Gently pull on
either side of the frame and lift
off of the nozzle.
Fig. 1
GS500CN_IB_EF_100813.indd 13
10-08-13 8:55 AM
