sharkclean .com
sharkclean .com
Regularly rinse and replace the filters to maintain your vacuum’s suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water
ONLY
. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
Pre-Motor (foam and felt):
With the dust cup removed, remove the
Foam
and
Felt Filters
.
CLEAN PRE-MOTOR FILTERS EVERY
3 MONTHS.
Post-Motor (HEPA):
To access the
HEPA filter
, press the tab, tilt
the
Filter Cover
, and lift it from the vacuum.
Remove the HEPA filter.
CLEAN HEPA FILTER EVERY YEAR.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
CLEANING THE BRUSHROLL
IMPORTANT:
DO NOT
use soap when cleaning the filters.
Foam Filter
Felt Filter
HEPA Filter
1.
Detach the pod from the floor nozzle.
2.
Remove any blockages or buildup from the airways in the
nozzle. With scissors, carefully cut away any fibers, hair,
or string wrapped around the brushroll. Avoid damaging
or cutting the bristles.
MAINTENANCE
To minimize the risk of power cord damage,
DO NOT
run the vacuum over the power cord. If this
occurs, immediately shut off power to the vacuum and remove the cord from the brushroll or nozzle.
1.
DO NOT
pull or carry vacuum cleaner by
the cord or use cord as a handle.
2.
DO NOT
unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT
close the door on the cord.
4.
DO NOT
pull the cord around sharp
corners.
5.
DO NOT
leave the cord near heated
surfaces.
CORD MAINTENANCE
NOTE:
To order replacement parts and filters, visit
sharkaccessories.com
.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF350
Replacement
HEPA Filter
XHF350
Follow the previous instructions for removing filters. The
Pre-Motor Filter
should be replaced every
2.5 years. The
HEPA Filter
should be replaced every 3 years.
REPLACING FILTERS
