Full
Charge
Nearly
Full
Mid
Charge
Low
Charge
Charging: One light flashes
TEMPERATURE ISSUE:
FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY
NOTE:
The battery must be charged before first use. A complete charge takes approximately 3.5 hours.
NOTE:
The indicator light will shut off 5 minutes after charging is complete.
Charge Indicator
Light
TOP OF BATTERY
CHARGE INDICATOR LIGHTS
If the first and third indicator lights are flashing alternately, the battery
temperature is not optimal. If this happens when charging, leave the battery
plugged in and charging will resume once temperature reaches optimal level.
OPERATING THE VACUUM
OPERATING THE VACUUM
POD, HANDLE, AND WAND ARE DETACHABLE
Detach the wand from the pod for
more reach to clean above-floor
areas. Press the
Wand Release
button and lift the wand to
remove it from the nozzle.
DETACH THE WAND
To clean above-floor areas
close at hand, press the
Handle
Release
trigger to detach the
handle from the wand.
DETACH THE HANDLE
Detach the pod from the floor
nozzle for powerful cleaning
under furniture and in other hard-
to-reach areas. Press the
LIFT-
AWAY
button and lift the pod off
the nozzle.
DETACH THE POD
TIP:
See next page for all the
different ways you can use
your vacuum.
Press power button
to turn the vacuum on
or off.
To vacuum in hard
floor mode, press
the floor select button
until the hard floor
icon (
) illuminates.
The brushrolls will
spin slower to clean
bare floors and small
area rugs.
Press the ( ) button to
toggle between ECO,
Deep Clean and Boost
modes. To save battery
power, select ECO
mode. For everyday
cleaning power, select
Deep Clean Mode. For
an extra burst of power,
select Boost mode.
To vacuum in carpet
mode, press the floor
select button until the
carpet icon (
)
illuminates. The
brushrolls will spin
faster to pick up debris
below the surface of
your carpets.
POWER ON/OFF
HARD FLOOR
SETTING
SUCTION MODES
CARPET SETTING
SETTINGS
Suction Speeds
Off
ECO
Deep Clean Mode
Boost
sharkclean .com
sharkclean .com
