sharkclean.eu
sharkclean.eu
USING
THE SHARK® AI ULTRA ROBOT
WET MOPPING SETUP
Secure the pad to the back of the reservoir.
Lift open the fill cap on the top of the reservoir. Fill
with water to the water line.
Attach the mop pad by inserting the flat edge of the
pad through the slot in the reservoir. Pull the mop pad
all the way through the slot until it is securely inserted.
NOTE:
Before it can mop, the robot
MUST
complete an
Explore Run
. After the Explore Run, you will have an
option to set up Carpet Zones and verify those carpets in the app with a Carpet Verification Run. This ensures
your robot will avoid carpets in mopping mode.
Firmly push the reservoir into the back of the robot,
behind the dust bin, and ensure the fluid reservoir
clicks into place.
USING
THE SHARK® AI ULTRA ROBOT
WET MOPPING SETUP
When the reservoir has fluid and is properly installed,
with the mop pad attached, the robot is ready to
vacuum and mop simultaneously. Press the
CLEAN
button on the robot or in the app to start a vacuuming
and mopping run. The robot will prime the mop pad
for 30 seconds before starting its run.
When mopping is complete, remove the reservoir by
pressing the fill port button and sliding the reservoir
out.
CAUTION:
Floors may be slippery after mopping.
Before your robot's first mopping run, set up
Carpet
Zones
in the app to ensure your robot will avoid
carpets and rugs when mopping. Follow instructions
in the app to set up Carpet Zones and to start a
Carpet Verification Run.
To remove the mop pad from the reservoir, detach
the pad from the back of the reservoir and slide the
pad out of the slot.
NOTE:
When mopping, your robot may travel over floor mats or rugs. Before the next mopping run, move
rugs or mats out of the robot’s path, or use the app to enable Carpet Zones or to set up no-go zones.
ENGLISH
