Shark SMT • 9.800-504.0
20
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
LOW OPERATING
PRESSURE
Faulty pressure gauge
Install new gauge.
Insuffi cient water supply
Use larger garden hose; clean fi lter washer at
water inlet.
Old, worn or incorrect spray
nozzle
Match nozzle number to machine and/or replace
with new nozzle.
Plumbing or hose leak
Check plumbing system for leaks.
Re-tape leaks with tefl on tape.
Faulty or mis-adjusted unloader
valve (where applicable)
Adjust unloader for proper pressure.
Install repair kit when needed.
Worn packing in pump
Install new packing kit.
Fouled or dirty inlet or discharge
valves in pump
Clean inlet or discharge valves.
Worn inlet or discharge valves
Replace with valve kit.
DETERGENT
NOT
DRAWING
Air leak
Tighten all clamps.
Check detergent lines for holes.
Valve in the injector head may be
blocked, dirty or damaged
Clean or replace valve in injector.
Filler screen on detergent suction
hose plugged
Clean or replace.
Dried up detergent plugging
metering valve
Disassemble and clean thoroughly.
High viscosity of detergent
Dilute detergent to specifi cations.
Hole in detergent line(s)
Repair hole.
Low detergent level
Add detergent if needed.
Discharge water temperature
above 180°F
Lower discharge water temperature.
PUMP RUNNING
NORMALLY BUT
PRESSURE LOW
ON INSTALLATION
Pump sucking air
Check water supply and possibility of
air seepage.
Valves sticking
Check and clean or replace if necessary.
Unloader valve seat faulty
Check and replace if necessary.
Nozzle incorrectly sized
Check and replace if necessary
(See serial plate for proper size).
Worn piston packing
Check and replace in necessary.
FLUCTUATING
PRESSURE
Valves worn
Check and replace if necessary.
Blockage in valve
Check and replace if necessary.
Pump sucking air
Check water supply and air seepage at joints in
suction line.
Worn piston packing
Check and replace if necessary.
